Question: How do you adjust the tension on a Brother sewing machine?

Turn the thread tension dial to a lower number (toward the left). (Loosen the thread tension.) When the upper thread is visible from the lower side of the fabric. Turn the thread tension dial to a higher number (toward the right).

What should the tension be set at on a Brother sewing machine?

The tension dial should be set between 2 to 6. b. When the upper thread is just visible on the back of the fabric, the thred tension is correct.

Why is my sewing machine looping underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

How do I reset the tension on my sewing machine?

Changing Bobbin Tension

Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension. Some quilters keep two bobbin cases on hand, leaving one as-is from the factory and using the other when they need to make adjustments.

INTERESTING:  Quick Answer: What is a close knit family group?

Which way do you turn tension dial?

Turn the thread tension dial counterclockwise to loosen the upper thread tension.

What thread tension should I use?

The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.

How do I know if my bobbin tension is correct?

The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.

Why is bottom stitch loose?

Probable Causes: – Top or bobbin thread is not set correctly. – Make sure that the bobbin was threaded properly in the shuttle race. …

Why is the tension wrong on my sewing machine?

Needles, threads, and fabrics: Different thread sizes and types on top and in the bobbin can throw off basic tension settings. A needle that’s too large or small for the thread can also unbalance your stitches, because the size of the hole adds to or reduces the total top tension.

How do you adjust top stitch tension?

To increase your top tension if it’s too loose, turn your knob so that the numbers are increasing. Try ½ to 1 number higher, then test the stitches on a piece of scrap fabric. Continue until it looks even on both sides and you can no longer see the bobbin thread on the right side of the fabric.

INTERESTING:  What is made by interlacing two sets of yarns at right angles to each other?