If the machine is threaded wrong, not only does it make the thread breaks easier, but is also more likely to create loose stitches. Check the threading to see if the thread has passed through the entire thread guides, the take-up lever and the eye of the needle.
Probable Causes: – Top or bobbin thread is not set correctly. – Thread tension setting is not properly set. …
You should see a small screw on the flat/closed side of the bobbin case. Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension.
How do you fix a lower bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.
Why is the tension wrong on my sewing machine?
When sewing fabrics together problems can occur when the thread tension is not correct, the needle or bobbin is not inserted properly, or the machine is not threaded correctly. … Check you have chosen the right needle size and thread to suit the fabric type and weight.
Threads can get bunched up at the beginning of sewing if the top and bobbin threads have not been properly placed underneath the presser foot before starting to sew. Ensure that both threads are under the presser foot and placed toward the back of the machine before lowering the presser foot to start sewing.
What are three possible causes of skipped stitches?
10 reasons for skipped stitches
- Improper threading.
- Poor clamping or insufficient pressure (flagging).
- The needle needs replacing.
- Wrong size needle.
- Wrong type of needle for the material.
- Wrong thread for the application.
- Poor quality thread.
Why is my thread looping underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. … In this case, it might be necessary to loosen both the bobbin tension AND the top tension.
Why does my bobbin case keep moving?
– Make sure you are using the correct bobbin for your machine. – Check that the thread was wound correctly on the bobbin. – Make sure the bobbin was properly inserted. … – Check to see if the bobbin case is scratched or has a burr on it.
Why is my thread looping?
Looped stitches are usually caused by improper tension. If the loop is on the upper side, it may be corrected by loosening the top tension or by tightening the lower tension. If the loop is on the under side, it is usually best corrected by adjusting the upper tension.